Gate and Garage Door Snagging Checklist for Handover
Quick answer: Before you accept a new property, test the automatic gate and garage door for safe stopping and reversing, working photocells, a manual release that works with its key, every remote paired, smooth travel without scraping, and a tidy, sealed control box. Ask for the motor and board model, manuals and remote codes in writing.
Why snag the gate and garage door
Gates and garage doors are heavy moving machines. Report faults found at handover to the developer or contractor straight away; later claims can be harder. A short check is enough to catch most issues.
1. Safety tests
- Auto-reverse. Place a solid object, such as a cardboard box, in the path of a closing garage door. It should stop and reverse on contact.
- Photocells. While the gate or door closes, break the beam with your hand or a box. It should stop or reopen at once. See our photocell guide.
- Safety edge. If fitted, press the rubber edge while the gate moves; it should stop or reverse. Our safety edge guide explains how they work.
- Flashing light. Check that it flashes whenever the gate moves.
2. Movement
- Full open and close without scraping, jerking or stopping part-way.
- Sliding gates: no grinding at the rack, the gate stays upright on its track.
- Swing gates: both leaves meet evenly and do not hit pillars or walls.
- Garage doors: rise and lower evenly on both sides, with no gaps at the floor.
- Limits stop the gate in the same place each time. Uneven stops can point to a limit switch or encoder fault.
3. Manual release
Ask for the release key. With the power off, release the motor, move the gate or door by hand, then re-lock it. Make sure you know where the key is kept.
4. Remotes and access
- Count the remotes handed over and test each one from the street.
- Ask whether any other remotes are coded to the receiver. If in doubt, ask for the memory to be cleared and your remotes re-coded.
- Test keypads, intercom or GSM openers if fitted. See gate remote not working for quick checks.
5. Electrics and installation
- The control box is closed, sealed and not at ground level where water collects.
- Cables run in conduit with glands, not loose.
- There is a labelled isolator near the motor.
- The motor base is solid, level and above surface water.
6. Paperwork to request
- Motor and control board make and model.
- Gate or door dimensions and weight, if known.
- Manuals and the installer’s contact details.
- Remote codes or the receiver type.
What to do with the snag list
Send your list with photos and short videos to the developer or contractor. If you need a second opinion or parts, we supply garage door motors, gate remotes, photocells and spare parts across Dubai, Sharjah, Abu Dhabi and Ajman.
Frequently asked questions
What should I check on an automatic gate at handover?
Safe stopping and reversing, photocells, the manual release, every remote, smooth travel and the condition of the control box and cables.
How do I test garage door auto-reverse?
Place a solid box in the door’s path while it closes. The door should stop and reverse when it touches it.
Should old remotes be deleted at handover?
If you are not sure who else has a remote, ask for the receiver memory to be cleared and your remotes re-coded.
What documents should come with the gate motor?
The motor and board model, manuals, installer contact details and remote information.
