Sliding Gate Pedestrian Opening: How Partial Open Works
Quick answer: Pedestrian (partial) opening makes a sliding gate open only part of its travel, wide enough for a person, then close again. It is a control-board function, not a separate motor. Most boards on the motors we list offer it through a second remote button, a keypad code or a dedicated input. The opening width is set during programming.
Why use a partial opening
A full opening on a long sliding gate takes time, lets dust and pets through, and leaves a wide gap for longer. A partial opening:
- lets someone on foot in or out without moving the whole leaf;
- shortens each cycle, so the motor runs less and builds up less heat;
- reduces wear on the rack, wheels and motor over a year of daily use.
It does not replace a separate pedestrian gate where one is required. Some makers state that vehicle automation should not be used as a pedestrian route, so check the site layout first.
How it works on the board
The control board counts motor travel through an encoder or timer. When it receives the “pedestrian” command, it drives the gate only to a set point and stops. Depending on the board settings, it then closes automatically after a pause or waits for another command.
Typical ways to trigger it:
- Second remote button. The receiver is coded so button 2 sends the partial command.
- Keypad or intercom. A wired input on the board marked for pedestrian or partial opening.
- Push button by the gate. Wired to the same input.
Examples from the motors we list
| Motor | What the maker calls it | Where it is set |
|---|---|---|
| Centurion D5-Evo SMART | Pedestrian opening | Set in the controller menu; width adjustable |
| BFT DEIMOS / ARES (BT A range) | Pedestrian opening (PED input) | Control unit menu and wired PED input |
| Nice ROBUS | Partial open | Programmed on the board; assignable to a remote button |
Browse the full range on our sliding gate motors page, for example the Centurion D5-Evo, Nice ROBUS 600 and BFT DEIMOS BT A600.
Setting the width
Most boards let the installer set the pedestrian width during learning, or as a percentage of full travel. A clear gap of around one metre usually suits people on foot. If the gate tail or a pillar narrows the opening, measure the real clear width after setting it.
Safety still applies
Photocells and safety edges work in partial mode too. If people use the partial opening often, a photocell pair at the pedestrian gap is worth adding. See our photocell sensors and our gate safety edge guide.
Adding it to an existing gate
If your board supports the function, it can usually be enabled by reprogramming and coding a remote button. Older boards without it may need a replacement control board or a receiver with a spare channel from our radio receivers range. Send the board model and a photo, and we will check what is possible. We work across Dubai, Sharjah, Abu Dhabi and Ajman.
Frequently asked questions
Can any sliding gate open halfway?
Only if the control board has a partial or pedestrian function. Most current boards on the motors we list do; older or basic boards may not.
How do I open my gate partly with the remote?
A spare remote button is coded to the board’s pedestrian input. Once set, that button opens the gate to the programmed width.
Does partial opening work on swing gates?
On double-leaf swing gates, the equivalent is usually opening one leaf only. Check the board manual for your motor.
Will the gate close by itself after a partial opening?
It can. Most boards offer automatic closing after a set pause, adjustable during programming.
